Air Quality Device Design - Intermediate

In this course you will learn how to create and design the enclosure for the air quality measuring device. You will go through all of the steps, from planning and writing down requirements of the enclosure (e.g. waterproofing the case), to sketching, drawing and finally 3D modelling the parts. After you are done with all of the steps of the design process, you will learn about 3D printing, setting up the model for the print, optimizing the settings for the best quality and finally 3D print the enclosure. This is an intermediate tutorial, meaning that you will need a certain amount of modeling experience in similar modeling software.

1 tutorial

Air quality device design - Intermediate

This tutorial will show you how to model an enclosure that needs to house existing circuit board with additional parts attached to it. You will go through the planning phase, and later move on to model bottom and top parts of the case. Tutorial tempo requires some previous knowledge of SolidWorks and 3D modeling, so if you are a beginner, you can check out our easier, basic ...